---

gandalf - 2007-02-19, 20:55
dobrze, koledzy sympatycy FORDóW po dłuższych poszukiwaniach linki znalazłem ją gość z Wawy ma chyba wszystko,
ale teraz pytanie jak ona powinna być ustawiona ile naciągnięta
czy po prostu zasadą prób i błędów ustawiać rundka i znowu
moze ktoś już ustawiał i by doradził

---

Bogdan - 2007-02-19, 22:50
Oj to się naszukałeś, a co ten gość jeszcze ma?

Pozdrowienia

---

LTC - 2007-03-16, 08:04
Linka do kickdowna jest bardzo ważna, podobno może szybko pójść skrzynia gdy nie jest dobrze ustawiona. Ja w swoim ustawiałem wg tego topicu ale wyszło mi że jest dobrze. Natomiast nie rozumiem jednej rzeczy, te wszystkie instrukcje każą najpierw ustawić linkę od przepustnicy powietrza, tylko po co, to jest jakiś błąd. Jeśli przepustnica opiera się o swój stop, to nie trzeba tego robić.

Poniżej procedura to twojego modelu:
THROTTLE CABLE
NOTE: Transaxle downshift control is controlled through the throttle position switch on 1991–95 vehicles equipped with the electronic automatic overdrive transaxle.

1986–90 3.0L and 3.8L Engines
The Throttle Valve (TV) cable normally does not need adjustment. The cable should be adjusted only if one of the following components is removed for service or replacement:

-Main control assembly
-Throttle valve cable
-Throttle valve cable engine mounting bracket
-Throttle control lever link or lever assembly
-Engine throttle body
-Transaxle assembly

1. Connect the TV cable eye to the transaxle throttle control lever link, then attach the cable boot to the chain cover.

2. If equipped with the 3.0L engine, with the TV cable mounted in the engine bracket, make sure the threaded shank is fully retracted. To retract the shank, pull up on the spring rest with the index fingers and wiggle the top of the thread shank while pressing the shank through the spring with the thumbs.

3. If equipped with the 3.8L engine, the TV cable must be unclipped from the right intake manifold clip. To retract the shank, span the crack between the two 180 degree segments of the adjuster spring rest with a suitable tool. Compress the spring by pushing the rod toward the throttle body with the right hand. While the spring is compressed, push the threaded shank toward the spring with the index and middle fingers of the left hand. Do not pull on the cable sheath.

Fig. 1: While the spring is compressed, push the threaded shank toward the spring with the index and middle fingers of the left hand. Do not pull on the cable sheath


4. Attach the end of the TV cable to the throttle body.

5. If equipped with the 3.8L engine, rotate the throttle body primary lever by hand, the lever to which the TV-driving nailhead is attached, to the wide-open-throttle position. The white adjuster shank must be seen to advance. If not, look for cable sheath/foam hang-up on engine/body components. Attach the TV cable into the top position of the right intake manifold clip.

NOTE: The threaded shank must show movement or "ratchet'' out of the grip jaws. If there is no movement, inspect the TV cable system for broken or disconnected components, then repeat the procedure.

Fig. 2: The threaded shank must show movement or "ratchet'' out of the grip jaws. If there is no movement, inspect the TV cable system for broken or disconnected components, then repeat the procedure